Creative 3D Blaster Installation Guide download pdf (Page 7)

3D Blaster RIVA TNT2 PCI Installation Guide 7

7. In the Insert Disk message box, click the OK button.

8. In the Copying Files dialog box, type D:\WINDOWS and click the OK button.

The drivers are copied to your system.

9. In the Update Device Driver Wizard dialog box, click the OK button.

10. When prompted to restart your system, click the Yes button.

11. After the system has restarted, proceed to install the applications. Click Start and select Run.

12. In the Run dialog box, type D:\WINDOWS\SETUP and click the OK button.

13. Follow the instructions on the screen to complete the setup.

If you do not install all the applications now, you can install them later.

To install in

Windows 98

1. Switch on your system.

Windows 98 automatically detects the graphics card.

An “Add New Hardware Wizard” message box appears, informing you that a display adapter

has been detected.

2. When a dialog box similar to the figure

opposite appears, select the option “Display a

list of all the drivers in a specific location”, so

you can select the driver you want.

3. Click the Next button.

4. Insert the 3D Blaster RIVA TNT2 PCI CD

into your CD-ROM drive.

5. In the Models list box, click the “Have Disk”

button.

6. In the “Install From Disk” dialog box, type

D:\WINDOWS (where D: represents your

CD-ROM drive) and click the OK button.

If you are installing 3D Blaster RIVA TNT2 PCI as a second or subsequent card to make use

of Windows 98’s multi-monitor capability, you will see an Update Driver Warning message

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

No comments

Creative 3D Blaster Installation Guide Page 7