Creative 3D Blaster Installation Guide download pdf (Page 6)

3D Blaster RIVA TNT2 PCI Installation Guide 6

4. Insert the 3D Blaster RIVA TNT2 PCI CD into your CD-ROM drive.

5. In the “Install From Disk” dialog box, type D:\WINDOWS\Language (where D: represents

your CD-ROM drive and Language represents the langauge of the software you want to

install). Click the OK button.

6. If prompted to select drivers, click the Creative CT6955 drivers.

The drivers are copied to your system.

7. When prompted to restart your system, click the Yes button.

8. After the system has restarted, proceed to install the applications. Click Start and select Run.

9. In the Run dialog box, type D:\WINDOWS\SETUP and click the OK button.

10. Follow the instructions on the screen to complete the setup.

If you do not install all the applications now, you can install them later.

To install in

Windows 95

(OSR version 2.0

and later)

1. Switch on your system.

Windows 95 automatically detects the graphics card.

A “New Hardware Found” message box appears, informing you that a display adapter has

been detected.

2. When a dialog box similar to figure opposite

appears, click the Next button.

3. Click the Other Locations button when it

appears in the “Update Device Driver

Wizard” dialog box.

4. Insert the 3D Blaster RIVA TNT2 PCI CD

into your CD-ROM drive.

5. In the Select Other Location dialog box, type

D:\WINDOWS (where D: represents your

CD-ROM drive) and click the OK button.

6. In the Update Device Driver Wizard dialog

box, click the Finish button.

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

No comments

Creative 3D Blaster Installation Guide Page 6