Creative 3D Blaster Installation Guide download pdf (Page 18)

3D Blaster RIVA TNT2 PCI Installation Guide 18

Problems Using Software

When you restart Windows, one of the following error messages appears:

❑ “BlasterControl will only work on Creative graphics product drivers.

Do you want BlasterControl to be loaded the next time you start Windows?”

❑ “BlasterControl will only work on Creative graphics product drivers.”

Cause 3D Blaster RIVA TNT2 PCI drivers, required by BlasterControl, may have been

replaced by other drivers when you installed DirectX applications.

Solution Re-install or revert to the 3D Blaster RIVA TNT2 PCI drivers.

To revert to the drivers:

1. Right-click your desktop, and then click Properties on the shortcut menu.

2. In the “Display Properties” dialog box, click the Settings tab, and then click

the “Change Display Type” button or the “Advanced Properties” button.

3. In the “Adapter Type” group box or on the Adapter tabbed page, click the

Change button.

4. In the “Select Device” dialog box, click “Creative CT6955”, and then click the

OK button.

5. In the Insert Disk message box, click the OK button without inserting any CD.

6. If 3D Blaster RIVA TNT2 PCI drivers and later versions of DirectX drivers

are already installed, click the “Skip File” button until the “Adapter Type”

group box or the Adapter tabbed page appears.

7. Click the two Close buttons to close the Display Properties dialog box.

8. When prompted to restart your system, click the Yes button.

After you have restarted your system, the newer DirectX drivers will work

with the latest 3D Blaster RIVA TNT2 PCI drivers.

1 2 ... 13 14 15 16 17 18 19 20 21 22

No comments

Creative 3D Blaster Installation Guide Page 18