Creative 3D Blaster User's Guide download pdf (Page 34)

Using BlasterControl 4-10

Correcting Display Settings

You may inadvertently select a display setting that causes distortion, for

example, a high refresh rate that is not supported by your monitor. The

monitor starts to flicker.

To correct the settings:

1. Restart the system in Windows

Safe mode

a. Restart your system. When the message “Starting

Windows...” appears, press the F8 key on your keyboard.

A list of options appears.

b. Select Safe Mode and press the ENTER key.

2. Click the Start button, select Programs, then the Graphics

Blaster program folder, and then click Creative Rescue Utility.

The BlasterControl Rescue dialog (Figure 4-13) appears.

Figure 4-13: BlasterControl Rescue dialog.

3. In the Product Name list, click the name of your Graphics

Blaster video card. A list of resolutions appears in the Display

Setting To Clean Up list. Each resolution represents a group of

display settings.

4. Select the resolution that caused the screen distortion and click

the Clean Up button. For example, if a refresh rate of 75 Hz and

a resolution of 1024 x 768 caused the display problem, select the

“1024 x 768” entry and click the Clean Up button.

5. Click the Close button.

6. Restart your system in Windows

Normal mode

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

No comments

Creative 3D Blaster User's Guide Page 34