Creative 3D Blaster User's Guide download pdf (Page 17)

Installing Software 2-5

If you are installing Banshee as a second or subsequent card to

make use of Windows 98’s multi-monitor capability, you will

see an Update Driver Warning message telling you that the

driver you have selected may not work correctly. You

must

click

the No button to confirm that you want to use the selected driver.

Otherwise, the system will install the wrong driver and will not

recognize the card as a Banshee card (for details, See “Windows

98 Multi-Monitor Display Problems” on page 3-2.).

7. In the Select Device dialog, make sure the 3D BLASTER

BANSHEE entry in the Models list is selected and click the OK

button.

8. Click the Next button.

9. Click the Finish button.

The drivers are copied to your system.

10. When prompted to restart your system, click the Yes button.

11. After the system has restarted, proceed to install the

applications. Click the Start button on your taskbar, and then

click Run.

12. In the Run dialog, type

D:\WINDOWS\SETUP

and click the

OK button.

13. Follow the instructions on the screen to complete the setup.

If you do not install all the applications now, you can install

them later.

If you are installing two or more Banshee cards, verify that each

Banshee card is working properly with its corresponding

monitor after completing the hardware and driver installation.

Repeat this procedure for each subsequent card.

Installing Software in Windows NT 4.0

To install the 3D Blaster Banshee software for Windows NT 4.0:

1. Switch on your system. In Windows NT, right-click your

desktop, and then click Properties on the shortcut menu.

2. In the Display Properties dialog, click the Settings tab.

3. On the Settings tab page, click the Display Type button.

4. In the Display Type dialog, click the Change button.

5. In the Change Display dialog, click the Have Disk button.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

No comments

Creative 3D Blaster User's Guide Page 17