Creative Sound Blaster Audigy 2 User Manual download pdf (Page 55)

Troubleshooting and FAQs B-3

To record an individual analog source:

❑ In the Record panel of the Basic tab in Creative Surround Mixer, make sure the recording source

selected is Analog Mix (Line/CD/TAD/Aux/PC).

❑ In the Source panel, mute the analog sources that you do not want to record by clicking the Speaker

button to change it to a button with a red cross sign on it.

No sound from the speakers.

Check the following:

❑ You have connected your speakers to your card's output.

❑ You have selected the correct source in the Source panel Creative Surround Mixer.

❑ If both the above conditions have been met and you still do not get any sound, click the red plus sign

above the Volume control and check whether the Digital Output Only check box is selected. If it is,

you are in the Digital Output Only mode and so must connect to digital speakers to hear the sound from

your audio card. See the section on “Speaker Selection Settings” in Creative Speaker Setting’s online

Help for more information.

No audio output when playing digital files such as .WAV, MIDI files or AVI clips.

Check the following:

❑ The speakers’ volume control knob, if any, is set at mid-range. Use Creative Surround Mixer to adjust

the volume, if necessary.

❑ The powered speakers or external amplifier are connected to the card’s Line Out or Rear Out jack.

❑ There is no hardware conflict between the card and a peripheral device. See “Resolving I/O Conflicts”

on page B-11.

❑ The Speaker selection in Creative Speaker Settings corresponds to your speaker or headphone

configuration.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 66 67

No comments

Creative Sound Blaster Audigy 2 User Manual Page 55