Creative 3D Blaster User's Guide download pdf (Page 18)

10 3D Blaster™ Savage 4

7. In the Select Device dialog box, make sure the 3D Blaster Savage4 entry in the Models list

is selected and click the OK button.

8. Click the Next button.

9. Click the Finish button.

The drivers are copied to your system.

10. When prompted to restart your system, click the Yes button.

11. After the system has restarted, proceed to install the applications.

Click Start -> Run.

12. In the Run dialog box, type D:\WINDOWS\SETUP and click the OK button.

13. Follow the instructions on the screen to complete the setup.

If you do not install all the applications now, you can install them later.

To install in

Windows NT 4.0

(Service Pack 3)

1. Click Start -> Run.

2. In the Run dialog box, type D:\WINNT40\SETUP and click the OK button.

3. Follow the instructions on the screen to complete the setup.

If you do not install all the applications now, you can install them later.

4. If the Invalid Display Settings message box appears after your system has restarted, click the

OK button and change the display settings.

For details, see “To change the display settings in Windows NT 4.0” on page 10.

Changing

Settings

To change the

display settings in

Windows NT 4.0

1. Right-click your desktop, and then click Properties on the shortcut menu.

2. In the Display Properties dialog box, click the Settings tab.

3. In the Desktop Area group box, move the slider to set the desired resolution.

If you are installing two or more

Savage4 cards, verify that each

Savage4 card is working properly

with its corresponding monitor

after completing the hardware

and driver installation. Repeat

this procedure for each

subsequent card.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

No comments

Creative 3D Blaster User's Guide Page 18